SKRpro1.3 mount for CR-X
By neil_taylor
SKRpro1.3 mount for CR-X
Fits onto the mount points for the original CR-X main board.
You need to cut away part of the vent on the side of the CR-X case, which will give you access to the on-board USBs and microSD card slot (see pics). With this mount the USB ports end up flush with the outside of the case, so the board won’t fit unless you do this.
I added a couple of 5015 fans on stilts to cool the drivers – set in the firmware to turn on when any drivers are enabled. I just stuck them to the CR-X case with double-sided duct tape.
December 8, 2021 at 09:26PM
via Thingiverse – Newest Things https://ift.tt/3rMbsnx
3d print ......errori ed esperienze, 
Rispondi