The #NanoLongRange-Top & Bottom Remix
By WingnutandWashout
I made a few changes to the Top and Bottom files.
Top Frame
First,I placed a support bracket between the Camera mount arms to accommodate the TBS Crossfire Immortal T V2 Antenna. Simply use small Zip Ties to attach the antenna to the bracket.
Secondly, I attached the Positive Symbol to the frame instead of the separate 3d printed version. Just use acrylic paint or red nail polish to make it stand out.
Third, the holes for the screws that support the Flight Controller all have the same depth so same length socket screws can be used.
Fourth, I fashioned a small indent for the negative wire from the battery tray so it wasn’t pinched between the frame and the battery tray bottom.
Fifth, the back of the frame has an antenna snap in bracket to hold the ipex Linear Brass Antenna, or a TrueRC Short Singularity antenna or antenna of your choosing.
Bottom Tray.
I increased the depth inside the bottom housing by 1mm. This just gave a little more room for the electronics. My ESC’s overheated when I was hovering while calibrating Auto level so I also made a version with more vents to improve heat dissipation and cooling.
December 8, 2021 at 07:22PM
via Thingiverse – Newest Things https://ift.tt/3lO8QS7
3d print ......errori ed esperienze, 
Rispondi